Peugeot 308 Key Fob Replacement
Peugeot's 308 might be catching on a little but it's still appealing. It's not the most luxurious vehicle in its class, but it's an enjoyable and comfortable drive.
Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. If the issue is ongoing or continuous the following tips will help.
Water Damage
If you accidentally drop your key fob in an eddy, or it is wet while kayaking, canoeing, rafting or canyoning the fob is most likely to be damaged by water. Keep your key fob in a dry container whenever you go outdoors or do activities that could expose it to a lot of water.
It's also important to make sure that the fob is completely dried before you open it and use it again. If you smell any odors from the fob (such as industrial fluid or windshield washer fluid), this is another indication that it's submerged.
A circuit board that is wet could cause the battery to dump its energy or even explode. If you can pull your keyfob 308 from the water and turn it upside up and shake as much water as possible before opening the casing. When you've opened it, take off the battery, and then clean the circuit board with an abrasive soaked in 90-percent isopropyl alcohol.
Other reasons your Peugeot 308 remote keyless entry system might stop working include the battery of your coin is dead or receiver module issues signal interference, a faulty electronic chip. If none of these causes the issue, try resetting the system by disconnecting the battery at 12 volts for approximately 15 minutes.
Dead Coin Battery
Peugeot cars come with a remote start system that allows drivers to start their car from a distance, allowing them to warm up or cool down the vehicle before they get in. This feature is extremely helpful particularly during the winter's cold and chilly months. The remote start system can be stopped for a variety of reasons, such as a dead coin-battery.
A coin-shaped battery that is located inside the key fob will last a time of between two and four years, depending on how often it is utilized and where it was purchased. The date of use is typically printed on the packaging or listed in the instruction manual.
If the key fob is not functioning after exposure to clean tap water then you must remove the battery, then clean the chip using a paper towel and isopropyl ethanol, then dry it completely before replacing it. If the key fob was exposed to salty or soapy water, it may have caused the chip to become damaged. You will need to replace it.
If you're unsure whether the battery is damaged You can test the voltage using a multimeter attached to both the minus and plus terminals. The voltage should be between 12 to 13 volts, but if it is lower, the battery should be replaced. You can also reset the computer onboard by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first, then negative cable). The engine should now begin.
Faulty Receiver Module
If you don't see "Key Detected" you might find that your receiver module is defective. It's that part that sends an indication to the car when your key fob is activated which also acts as an immobiliser. It stops it from starting unless the correct key is used.
This could be due to a range of factors including water damage or simply aging. If the electronic chip inside your Peugeot 308 keyfob has been damaged due to dirty tap water it could be because the keyfob was exposed to it. In this instance, you'll have to take it off and clean it thoroughly using isopropyl or an electronic cleaner. Once the battery is dry, you can try again.
If the issue persists, it is a good idea that you visit an area Peugeot expert or locksmith. They can use an instrument for diagnosing to pinpoint the issue and fix it.
It is stressful to lose your Peugeot car key. A reputable auto locksmith can resolve the issue within minutes. They can cut a brand new key and programme it to your vehicle, making sure you can get back off the road in the shortest time possible. Click here to find a local locksmith near you.
Faulty Electronic Chip
The chip in the Peugeot 308 key fob plays a vital role in the remote control system. If it is damaged your car might not start or receive a message stating "anti-theft active". In this case the only option is to replace the key. Fortunately, professional auto locksmiths can complete the task in the shortest amount of time.
The chip in the key fob of your Peugeot 308 may become faulty for different reasons, including water damage, sweat or dirt. If your Peugeot 308 key fob has been exposed to soapy water, cleanse it immediately. You can make use of a paper towel and isopropyl alcohol to wipe the electronic component. After that, you should allow the battery to completely dry.
Radio interference can cause a key fob's functionality to cease. This can be caused by other devices that operate on the same frequency as your Peugeot key fob. It can also be caused by weather conditions or objects in the vicinity. If you encounter this issue it is advised to visit the Peugeot dealership.
The Peugeot key fob 207/308 is very delicate and requires a lot of attention. It should not be dropped or throw it around. If you lose something, try to find it as quickly as you can. peugeot 3008 key can reset all on-board computers by disconnecting the 12 volt battery for a few minutes. Remove the negative cable before the positive.